CHIAMARE PER QUOTAZIONE
 
Power Output 75 watts per channel continuous from 20Hz to 20kHz. 1kHz total harmonic distortion typically 1% at 75 watts, below 0.05% at 1 watt. (Note that actual power output is dependent upon both line voltage and ‘condition’ i. e.: if power line has high distortion, maximum power will be affected adversely, although from a listening standpoint this is not very critical.
Power Bandwidth (-3dB points) 7Hz to 60kHz
Frequency Response (-3dB points at 1 watt) 0.7Hz to 80kHz
Input Sensitivity 1.4V RMS BAL for rated output. (25dB Bal gain into 8 ohms.
Input Impedance 300K ohms Balanced (150K ohms SE)
Output Impedance Non-inverting. Balanced input pin 2+ (IEC-268)
Output Taps 8 ohms, 4 ohms
Output Regulation Approximately 1.0dB 8 OHM LOAD TO OPEN CIRCUIT (Damping factor approximately 8)
Overall Negative Feedback 15dB
Slew Rate 10 volts/microsecond
Rise Time 4.0 microseconds
Channel Separation 112dB
Hum & Noise –84dBV weighted, 8 ohms tap
Signal to Noise 112dB
Control Power on/off, auto shut-off on/defeat, Input BAL/SE, RS232, 12V trigger
Ambient Air Temperature 30° C (86° F) maximum ambient air temperature
Power Supply Energy Storage Approximately 350 joules
Power Requirements 100-125VAC 60Hz (200-250VAC 50Hz) 410 watts at rated output, 500 watts maximum, 230 watts idle. Sleep power < 1 watt
Tubes Required 2 – Matched pair KT150 – Power Output; 2 – 6H30 Driver
Dimensions width: 19” (48.3 cm)
height: 10.33” (26.2 cm)
depth: 18.45” (46.8 cm) to chassis , 19.40” (49.3 cm) to terminals
Weight 45.7lbs. (20.7 kg) Net; 60.5 lbs. (27.4 kg)